Configuring Generic MRP Protocol Parameters
Perform this task to configure the generic MRP protocol parameters for PBB-VPLS flood optimization.
SUMMARY STEPS
1. configure
2. mmrp-flood-optimization
3. (Optional) periodic transmit interval seconds
4. (Optional) join-time milliseconds
5. (Optional) leaveall-time seconds
6. (Optional) leave-time seconds
7. (Optional) flood-time seconds
8. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 mmrp-flood-optimization
Example:
RP/0/RSP0/CPU0:router(config)# mmrp-flood-optimization
Enables the flood optimization for PBB over VPLS feature on the core bridge.
Step 3 (Optional) periodic transmit interval seconds
Example:
RP/0/RSP0/CPU0:router(config-mmrp-flood-opt)# periodic transmit interval 3
Enables periodic Multiple MAC Registration Protocol Data Units (MMRPDUs).
Step 4 (Optional) join-time milliseconds
Example:
RP/0/RSP0/CPU0:router(config-mmrp-flood-opt)# join time interval 300
Sets the join time for all active ports.
Step 5 (Optional) leaveall-time seconds
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
369
Implementing IEEE 802.1ah Provider Backbone Bridge
Configuring Generic MRP Protocol Parameters
To Next Page
Loading...
Need help?
General
