!
!
Step 8 (Only PW-IW) interworking ipv4
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p-pw)# interworking ipv4
Configures the cross-connect p2p entity to use VC-type 11 or the IP interworking mode in the establishment of the
pseudowire.
Step 9 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring the Source Address
Perform this task to configure the local source address
Only IPv4 is supported as pw-class source address.
Note
SUMMARY STEPS
1. configure
2. l2vpn
3. pw-class class-name
4. encapsulation mpls
5. ipv4 source source-address
6. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
297
Implementing Multipoint Layer 2 Services
Configuring the Source Address
To Next Page
Loading...
Need help?
General
