Enables to run the group in singleton mode.
Step 5 backbone
Example:
RP/0/RSP0/CPU0:router(config-redundancy-iccp-group)# backbone
Configures ICCP backbone interface.
Step 6 interface GigabitEthernet GigabitEthernet Interface Instance
Example:
RP/0/RSP0/CPU0:router(config-redundancy-group-iccp-backbone)# interface GigabitEthernet 0/2/0/12
Configures GigabitEthernet interface.
Step 7 Use the commit or end command
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Enable Flow-based Load Balancing
Perform this task to enable flow-based load balancing.
SUMMARY STEPS
1. configure
2. l2vpn
3. load-balancing flow {src-dst-mac | src-dst-ip}
4. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
517
EVPN Features
Enable Flow-based Load Balancing
To Next Page
Loading...
Need help?
General
