RP/0/RSP0/CPU0:router# show l2vpn bridge-domain detail
Displays detailed sample output to specify that the MAC address withdrawal is enabled. In addition, the sample output
displays the number of MAC withdrawal messages that are sent over or received from the pseudowire.
Configuring the MAC Address Limit
Perform this task to configure the parameters for the MAC address limit.
SUMMARY STEPS
1. configure
2. l2vpn
3. bridge group bridge group name
4. bridge-domain bridge-domain name
5. (Optional) interface type interface_id
6. mac
7. limit
8. maximum { value }
9. action { flood | no-flood | shutdown }
10. notification { both | none | trap }
11. Use the commit or end command.
12. show l2vpn bridge-domain [ detail ]
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)#
Enters the L2VPN configuration mode.
Step 3 bridge group bridge group name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group csco
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
256
Implementing Multipoint Layer 2 Services
Configuring the MAC Address Limit
To Next Page
Loading...
Need help?
General
