• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring L2VPN MS-PW Address Family Under BGP
Perform this task to configure L2VPN MS-PW address family under BGP:
SUMMARY STEPS
1. configure
2. router bgp autonomous-system-number
3. address-family l2vpn mspw
4. neighbor ip-address
5. address-family l2vpn mspw
6. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 router bgp autonomous-system-number
Example:
RP/0/RSP0/CPU0:router(config)# router bgp 100
Enters router configuration mode for the specified routing process.
Step 3 address-family l2vpn mspw
Example:
RP/0/RSP0/CPU0:router(config-bgp)# address-family l2vpn mspw
Specifies the L2VPN address family and enters address family configuration mode.
Step 4 neighbor ip-address
Example:
RP/0/RSP0/CPU0:router(config-bgp)# neighbor 10.10.10.1
Adds the IP address of the neighbor in the specified autonomous system.
Step 5 address-family l2vpn mspw
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
176
Implementing Point to Point Layer 2 Services
Configuring L2VPN MS-PW Address Family Under BGP
To Next Page
Loading...
Need help?
General
