Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters Layer 2 VPN configuration mode.
Step 4 xconnect group group-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group pw-he1
Configures a cross-connect group name using a free-format 32-character string.
Step 5 p2p xconnect-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p pw-ss
Enters P2P configuration submode.
Step 6 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface gigabitethernet 0/1/0/9
Specifies the interface type and instance.
Step 7 neighbor routed global-id: prefix: ac-id source ac-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor routed 100:2.2.2.2:10 source 10
Enables pseudowire routing configuration submode for the p2p cross-connect.
Step 8 (optional) pw-class class-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p-pwr)# pw-class dynamic_sspw
Enters pseudowire class submode, allowing you to define a pseudowire class template.
Step 9 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
175
Implementing Point to Point Layer 2 Services
Configuring L2VPN VPWS SS-PW
To Next Page
Loading...
Need help?
General
