Configuring Source Bypass Filter
Perform this task to add a source bypass filter.
SUMMARY STEPS
1. configure
2. interface type interface-path-id.subinterface l2transport
3. Do one of the following:
• encapsulation dot1q vlan-id or
• encapsulation dot1ad vlan-id or
• encapsulation untagged or
• encapsulation dot1ad vlan-id dot1q vlan-id or
• encapsulation dot1q vlan-id second-dot1q vlan-id or
4. rewrite ingress tag translate translate 1-to-1 dot1q vlan-id symmetric
5. ethernet egress-filter disable
6. ethernet source bypass egress-filter
7. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters Global Configuration mode.
Step 2 interface type interface-path-id.subinterface l2transport
Example:
RP/0/RSP0/CPU0:router(config)# interface GigabitEthernet 0/2/0/4.1 l2transport
Enters subinterface configuration mode and enables Layer 2 transport mode on a port and enters Layer 2 transport
configuration mode.
Step 3 Do one of the following:
• encapsulation dot1q vlan-id or
• encapsulation dot1ad vlan-id or
• encapsulation untagged or
• encapsulation dot1ad vlan-id dot1q vlan-id or
• encapsulation dot1q vlan-id second-dot1q vlan-id or
Example:
RP/0/RSP0/CPU0:router(config-subif)#
encapsulation dot1q 10
or
RP/0/RSP0/CPU0:router(config-subif)#
encapsulation dot1ad 10
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
48
Ethernet Features
Configuring Source Bypass Filter
To Next Page
Loading...
Need help?
General
