Example:
RP/0/RP0/CPU0:router(config)# l2vpn
Enters L2VPN configuration mode.
Step 3 pw-class {name}
Example:
RP/0/RP0/CPU0:router(config-l2vpn)# pw-class path1
Configures the pseudowire class name.
Step 4 encapsulation mpls
Example:
RP/0/RP0/CPU0:router(config-l2vpn-pwc)# encapsulation mpls
Configures the pseudowire encapsulation to MPLS.
Step 5 preferred-path {interface} {tunnel-ip value | tunnel-te value | tunnel-tp value} [fallback disable]
Example:
RP/0/RP0/CPU0:router(config-l2vpn-pwc-encap-mpls)# preferred-path interface tunnel-te 11 fallback
disable
Configures preferred path tunnel settings. If the fallback disable configuration is used and once the TE/TP tunnel is
configured as the preferred path goes down, the corresponding pseudowire can also go down.
Step 6 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring PW Status OAM
Perform this task to configure pseudowire status OAM.
SUMMARY STEPS
1. configure
2. l2vpn
3. pw-oam refresh transmit seconds
4. endorcommit
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
126
Implementing Point to Point Layer 2 Services
Configuring PW Status OAM
To Next Page
Loading...
Need help?
General
