• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring CFM MEP
For more information about Ethernet Connectivity Fault Management (CFM), refer to the Configuring Ethernet
OAM on the Cisco ASR 9000 Series Router module in the Cisco ASR 9000 Series Aggregation Services Router
Interface and Hardware Component Configuration Guide.
Configuring an ERP Instance
Perform this task to configure an ERP instance.
SUMMARY STEPS
1. configure
2. l2vpn
3. bridge group bridge-group-name
4. bridge-domain domain-name
5. interface type port0-interface-path-id.subinterface
6. interface type port1-interface-path-id.subinterface
7. bridge-domain domain-name
8. interface type interface-path-id.subinterface
9. ethernet ring g8032 ring-name
10. instance number
11. description string
12. profile profile-name
13. rpl { port0 | port1 } { owner | neighbor | next-neighbor }
14. inclusion-list vlan-ids vlan-id
15. aps-channel
16. level number
17. port0 interface type path-id
18. port1 { interface type interface-path-id | bridge-domain bridge-domain-name | xconnect
xconnect-name | none }
19. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
280
Implementing Multipoint Layer 2 Services
Configuring CFM MEP
To Next Page
Loading...
Need help?
General
