Configuration on PE2:
redundancy
iccp
group 66
mlacp node 2
mlacp system mac 0aaa.0bbb.0ccc
mlacp system priority 1
backbone interface GigabitEthernet0/1/0/2
mode singleton
interface Bundle-Ether2
mlacp iccp-group 66
interface bundle-Ether2.1 l2transport
encapsulation dot1q 10
interface bundle-Ether2.20 l2transport
encapsulation dot1q 20
evpn
interface bundle-Ether2
ethernet-segment
identifier type 0 01.11.00.00.00.00.00.00.01
load-balancing-mode per-service
l2vpn
bridge group gr1
bridge-domain bd1
interface bundle-Ether2.1
pbb edge i-sid 300 core-bridge core_bd1
bridge-domain bd20
interface bundle-Ether2.20
pbb edge i-sid 320 core-bridge core_bd1
bridge group gr2
bridge-domain core_bd1
pbb core
evpn evi 1000
!
router bgp 100
bgp router-id 1.1.1.2
address-family l2vpn evpn
!
neighbor 1.1.1.100
remote-as 100
address-family l2vpn evpn
PBB EVPN on Dual Homed Device/Multi Homed Device with Active/Active
per Service load-balancing and Manual Service Carving
This example covers:
• PBB-EVPN service among three PEs in the same AS with a dual homed CE (behind PE1 and PE2) and
a single homed CE (behind PE3)
• PE1/PE2 configured to perform active/active per service (i.e. per-ISID) load balancing with manual
service carving/DF election
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
406
Implementing IEEE 802.1ah Provider Backbone Bridge
PBB EVPN on Dual Homed Device/Multi Homed Device with Active/Active per Service load-balancing and Manual Service Carving
To Next Page
Loading...
Need help?
General
