RP/0/RSP0/CPU0:router(config-evpn)# bgp
Enters EVPN BGP configuration mode and configures static BGP settings for the Ethernet Segment ES:GLOBAL EVI,
which is used for handling ES routes.
Step 4 rd { 2-byte as_number | 4-byte as_number | IP_address | none } : { nn }
Example:
RP/0/RSP0/CPU0:router(config-evpn-bgp)# rd 200:50
Configures the route distinguisher.
Step 5 exit
Example:
RP/0/RSP0/CPU0:router(config-evpn-bgp)# exit
Returns to the global configuration mode.
Step 6 evpn
Example:
RP/0/RSP0/CPU0:router(config)# evpn
Enters EVPN configuration mode.
Step 7 evi evi_id
Example:
RP/0/RSP0/CPU0:router(config-evpn)# evi 100
Configures Ethernet VPN ID.
The EVI ID range is from 1 to 65534.
Step 8 bgp
Example:
RP/0/RSP0/CPU0:router(config-evpn-evi)# bgp
Enters the BGP configuration mode for the specific EVI.
Step 9 route-target [ import | export ] { 2-byte as_number | 4-byte as_number | IP_address | none } : { nn }
Example:
RP/0/RSP0/CPU0:router(config-evpn-evi-bgp)# route-target 10:20
Creates a route-target extended community.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
392
Implementing IEEE 802.1ah Provider Backbone Bridge
Configuring BGP Route Target
To Next Page
Loading...
Need help?
General
