SUMMARY STEPS
1. configure
2. l2vpn
3. bridge group group_name
4. bridge-domain bridge_domain_name
5. pbb core
6. evpn evi evi_id
7. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters L2VPN configuration mode.
Step 3 bridge group group_name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group group1
Enters bridge group configuration mode. This command creates a new bridge group. A bridge group organizes bridge
domains.
Step 4 bridge-domain bridge_domain_name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg)#bridge-domain sample-pbb-core#
Enters bridge group domain configuration mode. This command creates a new bridge domain.
Step 5 pbb core
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# pbb core
Configures the bridge domain as PBB core and enters the PBB core configuration submode.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
387
Implementing IEEE 802.1ah Provider Backbone Bridge
Configuring PBB Core Bridge Domains
To Next Page
Loading...
Need help?
General
