Configuring Access Pseudowire in I-Component 382
Configuring Core Pseudowire in B-Component 385
Configuring PBB-EVPN 386
Configuring PBB Core Bridge Domains 386
Configuring PBB Edge Bridge Domains 388
Configuring EVPN Ethernet Segment 388
Configuring BGP Route Target 391
Configuring Global EVPN Timers 393
Configuring EVPN Timers Per Ethernet Segment and CE flushing mechanism 394
Configuring Multichassis Link Aggregation 396
Configuring BGP Routing Process 396
Configuration Examples for Implementing 802.1ah Provider Backbone Bridge 398
Configuring Ethernet Flow Points: Example 398
Configuring PBB Edge Bridge Domain and Service Instance ID: Example 398
Configuring PBB Core Bridge Domain: Example 399
Configuring Backbone VLAN Tag: Example 399
Configuring Backbone Source MAC Address: Example 399
Configuring Static Mapping and Unknown Unicast MAC Address under the PBB Edge Bridge
Domain 399
Configuring PBB-VPLS: Example 400
Configuring MIRP Lite: Example 400
Configuring PBB-EVPN: Example 401
PBB-EVPN on Single Homed Device/Single Homed Network 401
PBB EVPN on Dual Homed Device/Multi Homed Device with Active/Active per Flow
load-balancing 402
PBB EVPN on Dual Homed Device/Multi Homed Device with Active/Active per Service
load-balancing and Dynamic Service Carving 404
PBB EVPN on Dual Homed Device/Multi Homed Device with Active/Active per Service
load-balancing and Manual Service Carving 406
PBB-EVPN Multi Homed Network 409
Implementing Multiple Spanning Tree Protocol 411
CHAPTER 8
Prerequisites for Implementing Multiple Spanning Tree Protocol 411
Information About Implementing Multiple Spanning Tree Protocol 412
Spanning Tree Protocol Overview 412
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
xvi
Contents
To Next Page
Loading...
Need help?
General
