RP/0/RSP0/CPU0:router (config)# l2vpn
Enters Layer 2 VPN configuration mode.
Step 3 xconnect group group-name
Example:
RP/0/RSP0/CPU0:router (config-l2vpn)# xconnect group g1
Configures the cross-connect group.
Step 4 p2p xconnect-name
Example:
RP/0/RSP0/CPU0:router (config-l2vpn-xc)# p2p xc3
Configures the point-to-point cross-connect.
Step 5 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router (config-l2vpn-xc-p2p)# interface GigabitEthernet0/0/0/4.2
Specifies the interface type ID.
Step 6 neighbor ipv6 peer-address pw-id pseudowire-id
Example:
RP/0/RSP0/CPU0:router (config-l2vpn-xc-p2p)# neighbor ipv6 1111:2222::cdef pw-id 1
Specifies the peer with which to cross connect, and configures the pseudowire segment for the cross-connect.
Step 7 l2tp static local session session-id
Example:
RP/0/RSP0/CPU0:router (config-l2vpn-xc-p2p-pw)# l2tp static local session 1
(Optional) Configures a static local session for the L2TP pseudowire.
If you configure the local session ID, it is ignored for decapsulation-side processing by the ASR9000 Series
routers.
Note
Step 8 l2tp static remote session session-id
Example:
RP/0/RSP0/CPU0:router (config-l2vpn-xc-p2p-pw)# l2tp static remote session 1
(Optional) Configures a static remote session for the L2TP pseudowire.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
157
Implementing Point to Point Layer 2 Services
Configuring Local and Remote Sessions
To Next Page
Loading...
Need help?
General
