You can configure the PWHE interface as well, using EVPN-VPWS. Refer to the Configuring Pseudowire
Headend, on page 292 module for more information.
Note
SUMMARY STEPS
1. configure
2. interface type interface-path-id
3. l2vpn
4. xconnect group group-name
5. p2p xconnect-name
6. interface type interface-path-id
7. neighbor evpn evi vpn-idtarget ac-id
8. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface TenGigE0/1/0/12
Enters interface configuration mode and configures an interface.
Step 3 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters Layer 2 VPN configuration mode.
Step 4 xconnect group group-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group xc1
Configures a cross-connect group name using a free-format 32-character string.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
179
Implementing Point to Point Layer 2 Services
Configuring EVPN-VPWS
To Next Page
Loading...
Need help?
General
