Cisco A9K-SIP-700 Configuration Guidelines

Step 3 bridge group bridge group name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group csco
RP/0/RSP0/CPU0:router(config-l2vpn-bg)#
Creates a bridge group so that it can contain bridge domains and then assigns network interfaces to the bridge domain.
Step 4 bridge-domain bridge-domain name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain abc
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)#
Establishes a bridge domain and enters L2VPN bridge group bridge domain configuration mode.
Step 5 vfi { vfi-name }
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# vfi v1
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-vfi)#
Configures the virtual forwarding interface (VFI) parameters and enters L2VPN bridge group bridge domain VFI
configuration mode.
• Use the vfi-name argument to configure the name of the specified virtual forwarding interface.
Step 6 exit
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-vfi)# exit
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)#
Exits the current configuration mode.
Step 7 neighbor { A.B.C.D } { pw-id value }
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# neighbor 10.1.1.2 pw-id 1000
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-pw)#
Adds an access pseudowire port to a bridge domain or a pseudowire to a bridge virtual forwarding interface (VFI).
• Use the A.B.C.D argument to specify the IP address of the cross-connect peer.
• Use the pw-id keyword to configure the pseudowire ID and ID value. The range is 1 to 4294967295.
Step 8 dhcp ipv4 snoop profile { dhcp_snoop_profile_name }
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
231
Implementing Multipoint Layer 2 Services
Configuring a Pseudowire

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English