RP/0/RSP0/CPU0:router(config-if)# load-interval 90
Specifies interval, in seconds, for load calculation for an interface.
The interval:
• Can be set to 0 [0 disables load calculation]
• If not 0, must be specified in multiples of 30 between 30 and 600.
Step 7 dampening decay-life
Example:
RP/0/RSP0/CPU0:router(config-if)# dampening 10
Configures state dampening on the given interface (in minutes).
Step 8 logging events link-status
Example:
RP/0/RSP0/CPU0:router(config-if)# logging events link-status
Configures per interface logging.
Step 9 (Only PW-Ether main interfaces) mac-address MAC address
Example:
RP/0/RSP0/CPU0:router(config-if)# mac-address aaaa.bbbb.cccc
Sets the MAC address (xxxx.xxxx.xxxx) on an interface.
Step 10 mtu interface_MTU
Example:
RP/0/RSP0/CPU0:router(config-if)# mtu 128
Sets the MTU on an interface.
Step 11 bandwidth kbps
Example:
RP/0/RSP0/CPU0:router(config-if)# bandwidth 200
Configures the bandwidth. The range is from 0 to 4294967295.
Step 12 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
300
Implementing Multipoint Layer 2 Services
Configuring PWHE Interface Parameters
To Next Page
Loading...
Need help?
General
