Cisco A9K-SIP-700 Configuration Guidelines

Configures the PWHE interface and enters the interface configuration mode.
Step 3 ipv4 address ip-address subnet-mask (or) ipv6 address ipv6-prefix/prefix-length
Example:
RP/0/RSP0/CPU0:router(config-if)# ipv4 address 40.1.1.2 255.255.255.0
Sets the IPv4 or IPv6 address of the main interface.
Step 4 attach generic-interface-list interface_list_name
Example:
RP/0/RSP0/CPU0:router(config-if)# attach generic-interface-list pw_he
Attaches the generic interface list to the interface.
Step 5 interface pw-ether id.subintfid l2transport
Example:
RP/0/RSP0/CPU0:router(config-if)# interface PW-Ether1.1 l2transport
Configures the PWHE sub-interface and enters the sub-interface configuration mode.
Step 6 encapsulation dot1q value
Example:
RP/0/RSP0/CPU0:router(config-subif)# encapsulation dot1q 1
Defines the matching criteria to map 802.1Q frames ingress on an interface to the appropriate service instance.
Step 7 l2vpn
Example:
RP/0/RSP0/CPU0:router(config-subif)# l2vpn
Enters Layer 2 VPN configuration mode.
Step 8 xconnect group group-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group xg
Configures a cross-connect group name using a free-format 32-character string.
Step 9 p2p xconnect-name
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
302
Implementing Multipoint Layer 2 Services
Configuring PWHE Layer 2 Subinterfaces and Adding it to the Bridge-domain

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English