Cisco A9K-SIP-700 Configuration Guidelines

6. multicast p2mp
7. signaling protocol bgp
8. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)#
Enters L2VPN configuration mode.
Step 3 bridge group bridge-group-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group bg1
Enters Layer 2 VPN VPLS bridge group configuration mode.
Step 4 bridge-domain bridge-domain-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain bd1
Enters Layer 2 VPN VPLS bridge group bridge domain configuration mode.
Step 5 vfi { vfi-name }
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# vfi v1
Configures the virtual forwarding interface (VFI) parameters and enters L2VPN bridge group bridge domain VFI
configuration mode.
• Use the vfi-name argument to configure the name of the specified virtual forwarding interface.
Step 6 multicast p2mp
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
314
Implementing Multipoint Layer 2 Services
Enabling P2MP PW with RSVP-TE on a VFI

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English