Cisco A9K-SIP-700 Configuration Guidelines

SUMMARY STEPS
1. configure
2. l2vpn
3. bridge group bridge-group-name
4. bridge-domain domain-name
5. interface type interface-path-id.subinterface
6. pbb edge i-sid service-id core-bridge core-bridge-name
7. unknown-unicast-bmac mac-address
8. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters L2VPN configuration mode.
Step 3 bridge group bridge-group-name
Example:
RRP/0/RSP0/CPU0:router(config-l2vpn)# bridge group pbb
Enters configuration mode for the named bridge group. This command creates a new bridge group or modifies the existing
bridge group if it already exists. A bridge group organizes bridge domains.
Step 4 bridge-domain domain-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain pbb-edge
Enters configuration mode for the named bridge domain. This command creates a new bridge domain or modifies the
existing bridge domain if it already exists.
Step 5 interface type interface-path-id.subinterface
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
379
Implementing IEEE 802.1ah Provider Backbone Bridge
Configuring Unknown Unicast Backbone MAC under PBB Edge Bridge Domain

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English