4. ethernet-segment
5. backbone-source-mac mac_address
6. force single-homed
7. identifier type esi-type esi-identifier
8. bgp route-target ipv4/v6-address
9. load-balancing-mode per-service
10. service-carving manual primary {isid} secondary {isid}
11. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 evpn
Example:
RP/0/RSP0/CPU0:router(config)# evpn
Enters EVPN configuration mode.
Step 3 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-evpn)# interface gigabitEthernet 0/1/0/4
Enters the physical port interface or the bundle interface configuration mode.
Step 4 ethernet-segment
Example:
RP/0/RSP0/CPU0:router(config-evpn-ac)# ethernet-segment
Enters the EVPN ethernet-segment configuration mode.
Step 5 backbone-source-mac mac_address
Example:
RP/0/RSP0/CPU0:router(config-evpn-ac-es)# backbone-source-mac 0045.1200.04
Configures the backbone source MAC address.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
389
Implementing IEEE 802.1ah Provider Backbone Bridge
Configuring EVPN Ethernet Segment
To Next Page
Loading...
Need help?
General
