2. evpn
3. interface nve nve-identifier
4. ethernet-segment
5. identifier type esi-type esi-identifier
6. bgp route-target route target value
7. Use the commit or end command
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the global configuration mode.
Step 2 evpn
Example:
RP/0/RSP0/CPU0:router# evpn
Enters EVPN configuration mode.
Step 3 interface nve nve-identifier
Example:
RP/0/RSP0/CPU0:router(config-evpn)# interface nve 1
Creates the NVE interface and enters the NVE interface configuration sub-mode
Step 4 ethernet-segment
Example:
RP/0/RSP0/CPU0:router(config-evpn-ac)# ethernet-segment
Enters the EVPN ethernet-segment configuration mode.
Step 5 identifier type esi-type esi-identifier
Example:
RP/0/RSP0/CPU0:router(config-evpn-ac-es)# identifier type 0 88.00.00.00.00.00.00.00.01
Configures Ethernet Segment Identifier .
Step 6 bgp route-target route target value
Example:
RP/0/RSP0/CPU0:router(config-evpn-ac-es)# bgp route-target 8888.0000.0001
Configures the BGP import route-target for the Ethernet-Segment.
Step 7 Use the commit or end command
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
515
EVPN Features
Configure Ethernet Segment Identifier
To Next Page
Loading...
Need help?
General
