Creates and names a new Ethernet link bundle.
This interface Bundle-Ether command enters you into the interface configuration submode, where you can enter
interface specific configuration commands are entered. Use the exit command to exit from the interface configuration
submode back to the normal Global Configuration mode.
Step 3 ipv4 address ipv4-address-address mask
Example:
RP/0/RSP0/CPU0:router(config-if)# ipv4 address 10.1.2.3 255.0.0.0
Assigns an IP address and subnet mask to the virtual interface using the ipv4 address configuration subcommand.
Step 4 bundle minimum-active bandwidth kbps (optional)
Example:
RP/0/RSP0/CPU0:router(config-if)# bundle minimum-active bandwidth 580000
Sets the minimum amount of bandwidth required before a user can bring up a bundle.
Step 5 bundle minimum-active links links (optional)
Example:
RP/0/RSP0/CPU0:router(config-if)# bundle minimum-active links 2
Sets the number of active links required before you can bring up a specific bundle.
Step 6 bundle maximum-active links links (optional)
Example:
RP/0/RSP0/CPU0:router(config-if)# bundle maximum-active links 1
Designates one active link and one link in standby mode that can take over immediately for a bundle if the active link
fails (1:1 protection).
The default number of active links allowed in a single bundle is 8.
If the bundle maximum-active command is issued, then only the highest-priority link within the bundle is
active. The priority is based on the value from the bundle port-priority command, where a lower value is
a higher priority. Therefore, we recommend that you configure a higher priority on the link that you want to
be the active link.
Note
Step 7 bundle maximum-active links links hot-standby
Example:
RP/0/RSP0/CPU0:router(config-if)# bundle maximum-active links 1 hot-standby
The hot-standby keyword helps to avoid bundle flaps on a switchover or switchback event during which the bundle
temporarily falls below the minimum links or bandwidth threshold.
It sets default values for the wait-while timer and suppress-flaps timer to achieve this.
Step 8 exit
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
60
Configuring Link Bundles
Configuring Ethernet Link Bundles
To Next Page
Loading...
Need help?
General
