A-66
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
Show Commands
Examples Example 1
acs/admin# show application
<name> <Description>
acs ACS 5.1
acs/admin#
Example 2
acs/admin# show application version acs
Cisco ACS VERSION INFORMATION
-----------------------------
Version : 5.1.0
Release : 100
acs/admin#
Example 3
acs/admin# show application status acs
ACS role: PRIMARY
Process 'database' running
Process 'management' running
Process 'runtime' running
Process 'view-database' running
Process 'view-jobmanager' running
Process 'view-alertmanager' running
Process 'view-collector' running
Process 'view-logprocessor' running
acs/admin#
Example 4
acs/admin# show application status acs
ACS role: PRIMARY
"ACS is busy applying a recent configuration change
requiring enabling/disabling of processes.
Status is unavailable.
Please check again in a minute."
acs/admin#
This message appears when a set of processes change because of a view node selection or Active
Directory configuration.
Status Description
Running When the application is in running state.
Execution Failed When the process has failed to start but still trying to start the process.
Not Monitored After watchdog failed to start the process as configured.
Restarting When either the process cannot be found or the process ID file is missing
and the watchdog restarts the process.
Initializing Intermediate state when the watchdog comes up or watchdog starts again to
monitor a process. This is shown also when any of the processes has failed
to pass the active test.
To Next Page
Loading...
