A-25
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
EXEC Commands
Related Commands
application reset-config
To reset an application configuration to factory defaults, use the application reset-config command in
the EXEC mode.
application reset-config application-name
Syntax Description
Defaults No default behavior or values.
Command Modes EXEC
Usage Guidelines You can use the application reset-config command to reset the ACS configuration to factory defaults
without reimaging the ACS appliance or VM.
Examples acs/admin# application reset-config acs
Application successfully reset configuration
acs/admin#
Related Commands
application start
To enable a specific application, use the application start command in the EXEC mode. To remove this
function, use the no form of this command.
application start application-name
Command Description
application install Installs an application bundle.
application start Starts or enables an application.
application stop Stops or disables an application.
application upgrade Upgrades an application bundle.
show application Shows application information for the installed application packages
on the system.
application-name Name of the application to reset its configuration to factory defaults. Up to
255
alphanumeric characters.
Command Description
acs reset-config Resets the ACS configuration to factory defaults.
To Next Page
Loading...
