A-24
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
EXEC Commands
Usage Guidelines Installs the specified application bundle on the appliance. The application bundle file is pulled from the
specified repository.
If you issue the application install or application remove command when another installation or
removal operation of an application is in progress, you will see the following warning message:
An existing application install, remove, or upgrade is in progress. Try again shortly.
Examples acs/admin# application install acs myremoterepository
Do you want to save the current configuration ? (yes/no) [yes] ?
Generating configuration...
Saved the running configuration to startup successfully
acs/admin#
Related Commands
application remove
To remove a specific application, use the application remove command in the EXEC mode. To remove
this function, use the no form of this command.
application remove application-name
Syntax Description
Defaults No default behavior or values.
Command Modes EXEC
Usage Guidelines Removes or uninstalls an application.
Examples acs/admin# application remove acs
acs/admin#
Command Description
application remove Removes or uninstalls an application.
application start Starts or enables an application.
application stop Stops or disables an application.
application upgrade Upgrades an application bundle.
show application Shows application information for the installed application packages
on the system.
remove Removes or uninstalls an application.
application-name Application name. Up to 255 alphanumeric characters.
To Next Page
Loading...
