Cisco CSACS-1121-K9 - Kron Policy-List; Logging

A-131
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
Configuration Commands
Examples acs/admin(config)# kron policy-list SchedBackupMonday
acs/admin(config-Policy List)# cli backup SchedBackupMonday repository SchedBackupRepo
acs/admin(config-Policy List)# exit
acs/admin(config)#
Related Commands
logging
To enable the system to forward logs to a remote system or to configure the log level, use the logging
command in Configuration mode. To disable this function, use the no form of this command.
logging {ip-address | hostname} {loglevel level}
Syntax Description
Defaults No default behavior or values.
Command Modes Configuration
Usage Guidelines This command requires an IP address or hostname or the loglevel keyword; an error occurs if you enter
two or more of these arguments.
Command Description
kron occurrence Specifies schedule parameters for a Command Scheduler occurrence
and enters the config-Occurrence configuration mode.
ip-address IP address of remote system to which you forward logs. Up to 32
alphanumeric characters.
hostname Hostname of remote system to which you forward logs. Up to 32
alphanumeric characters.
loglevel Configures the log level for the logging command.
level Number of the desired priority level at which you set the log messages.
Priority levels are (enter the number for the keyword):
• 0-emerg—Emergencies: System unusable.
• 1-alert—Alerts: Immediate action needed.
• 2-crit—Critical: Critical conditions.
• 3-err—Error: Error conditions.
• 4-warn—Warning: Warning conditions.
• 5-notif—Notifications: Normal but significant conditions.
• 6-inform—Informational messages. Default.
• 7-debug—Debugging messages.