Cisco CSACS-1121-K9 - Snmp-Server Contact; Snmp-Server Host

A-138
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
Configuration Commands
Examples acs/admin(config)# snmp-server community new ro
acs/admin(config)#
Related Commands
snmp-server contact
To configure the SNMP contact MIB value on the system, use the snmp-server contact command in
Configuration mode. To remove the system contact information, use the no form of this command.
snmp-server contact word
Syntax Description
Defaults No default behavior or values.
Command Modes Configuration
Usage Guidelines None.
Examples acs/admin(config)# snmp-server contact Luke
acs/admin(config)#
Related Commands
snmp-server host
To send SNMP traps to a remote user, use the snmp-server host command in Configuration mode. To
remove trap forwarding, use the no form of this command.
snmp-server host {ip-address | hostname} version {1 | 2c} community
Command Description
snmp-server host Sends traps to a remote system.
snmp-server location Configures the SNMP location MIB value on the system.
snmp-server contact Configures the SNMP contact MIB value on the system.
word String that describes the system contact information of the node. Up to 255
alphanumeric characters.
Command Description
snmp-server host Sends traps to a remote system.
snmp-server community Sets up the community access string to permit access to the SNMP.
snmp-server location Configures the SNMP location MIB value on the system.