Cisco CSACS-1121-K9 - How to Use this Guide; Who Should Read this Guide

ix
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Preface
This guide describes how you can configure and maintain Cisco Secure Access Control System
(ACS)
5.1 by using the command-line interface (CLI). Each topic provides a high-level summary of the
tasks required for using the CLI in the Cisco Application Deployment Engine (ADE) OS 1.2 that, in
combination with ACS
5.1, runs on the CSACS-1121 appliance.
This preface includes:
• Who Should Read This Guide, page ix
• How to Use This Guide, page ix
• How This Guide Is Organized, page x
• Document Conventions, page x
• Documentation Updates, page xi
• Related Documentation, page xi
• Obtaining Documentation and Submitting a Service Request, page xii
Note Use this guide in conjunction with the documentation listed in Related Documentation, page xi.
Who Should Read This Guide
The majority of the instructions in this guide are straightforward; however, a few are complex. Therefore,
only experienced users should use these instructions.
Note Use this guide in conjunction with the documentation listed in Related Documentation, page xi.
How to Use This Guide
Cisco makes the following recommendations for using this document:
• Read the document in its entirety. Subsequent sections build on information and recommendations
discussed in previous sections.
• Use this document for all-inclusive information about the ACS appliance.
• Do not vary the command-line conventions (see Document Conventions, page x).