A-27
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
EXEC Commands
Usage Guidelines Disables an application.
You cannot use this command to stop ACS.
Examples acs/admin# application stop acs
acs/admin#
Related Commands
application upgrade
To upgrade a specific application bundle, use the application upgrade command in the EXEC mode. To
remove this function, use the application remove command.
application upgrade application-bundle remote-repository-name
Syntax Description
Defaults No default behavior or values.
Command Modes EXEC
Usage Guidelines Upgrades an application bundle, preserving any application configuration data.
If you issue the application upgrade command when another application upgrade operation is in
progress, you will see the following warning message:
An existing application install, remove, or upgrade is in progress. Try again shortly.
Note You must upgrade the ADE-OS to 1.2.0.146 version before you upgrade to ACS 5.1. You can perform
ACS upgrade only on a standalone machine. For more details, refer to
Installation and Upgrade Guide
for the Cisco Secure Access Control System 5.1.
Command Description
application install Installs an application bundle.
application remove Removes or uninstalls an application.
application start Starts or enables an application.
application upgrade Upgrades an application bundle.
show application Shows application information for the installed application packages
on the system.
upgrade Upgrades a specific application bundle.
application-bundle Application name. Up to 255 alphanumeric characters.
remote-repository-name Remote repository name. Up to 255 alphanumeric characters.
To Next Page
Loading...
