Cisco CSACS-1121-K9 - EXEC Commands; Acs (Instance; Acs (Process; Acs Backup

A-4
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
EXEC Commands
EXEC Commands
Each EXEC command includes a brief description of its use, command syntax, usage guidelines, and
sample output.
Table A-3 lists the EXEC commands that this section describes.
acs (instance)
To start or stop an ACS instance, use the acs command in the EXEC mode.
acs {start | stop}
Syntax Description
Defaults No default behavior or values.
Command Modes EXEC
Ta b l e A-3 List of EXEC Commands
1
1. Commands marked with an asterisk (*) represent those that are specific to ACS functionality.
• acs (instance) *
• acs (process) *
• acs backup *
• acs-config *
• acs
config-web-interface
• acs delete core *
• acs delete log *
• acs patch *
• acs reset-config *
• acs reset-password *
• acs restore *
• acs support *
• application install
• application remove
• application reset-config
• application start
• application stop
• application upgrade
• backup *
• backup-logs
• clock
• configure
• copy *
• debug
• delete
• dir
• exit
• forceout
• halt
• help
• mkdir
• nslookup
• ping
• reload
• restore *
• rmdir
• show (see Show Commands)
• ssh
• tech
• telnet
• terminal length
• terminal session-timeout
• terminal session-welcome
• terminal terminal-type
• traceroute
• undebug
• write
start Starts an ACS instance.
stop Stops an ACS instance.