A-16
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
EXEC Commands
Command Modes EXEC
Usage Guidelines ACS patches contain small fixes that include isolated files, not a full version of the ACS software. ACS
patch installations and removals require that you restart ACS.
Examples Example 1
acs/admin# acs patch install acspatch.tar.gpg repository myrepository
Installing an ACS patch requires a restart of ACS services.
Would you like to continue? Y/N
Example 2
acs/admin# acs patch remove acspatch.tar.gpg repository myrepository
Removing an ACS patch requires a restart of ACS services.
Would you like to continue? Y/N
Related Commands
acs reset-config
To reset the ACS configuration to factory defaults, use the acs reset-config command in the EXEC
mode.
acs reset-config
Syntax Description No arguments or keywords.
Defaults No default behavior or values.
Command Modes EXEC
Usage Guidelines If you use the acs reset-config command to reset your ACS to the factory default configuration, any
configurations you have performed are lost; however, the appliance settings (such as network settings
and backup repositories) are not affected.
ACS does not need to be running when you use this command.
Examples acs/admin# acs reset-config
This command will reset the ACS configuration.
Command Description
show application Shows application status and version information.
show version Displays information about the software version of the system.
To Next Page
Loading...
