Cisco CSACS-1121-K9 - Show Inventory

A-75
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
Show Commands
RX bytes:574274908 (547.6 MiB) TX bytes:268869567 (256.4 MiB)
Interrupt:169
eth1 Link encap:Ethernet HWaddr 00:16:36:56:61:D1
inet6 addr: fe80::216:36ff:fe56:61d1/64 Scope:Link
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:177
lo Link encap:Local Loopback
inet addr:209.165.201.1 Mask:255.255.255.224
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:21617 errors:0 dropped:0 overruns:0 frame:0
TX packets:21617 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:3587148 (3.4 MiB) TX bytes:3587148 (3.4 MiB)
sit0 Link encap:IPv6-in-IPv4
NOARP MTU:1480 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
acs/admin#
Related Commands
show inventory
To display information about the hardware inventory, including the ACS appliance model and serial
number, use the show inventory command in the EXEC mode.
show inventory |
Syntax Description
Command Description
interface Configures an interface type and enters the interface configuration
submode.
| Output modifier variables:
• begin—Matched pattern. Up to 80 alphanumeric characters.
• count—Count the number of lines in the interface. Add number after the
word count.
• end—End with line that matches. Up to 80 alphanumeric characters.
• exclude—Exclude lines that match. Up to 80 alphanumeric characters.
• include—Include lines that match. Up to 80 alphanumeric characters.
• last—Display last few lines of output. Add number after the word last.
Up to 80 lines to display. Default 10.