Cisco CSACS-1121-K9 - Interface; Icmp Echo

A-123
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
Configuration Commands
Command Modes Configuration
Usage Guidelines None.
Examples acs/admin(config)# icmp echo off
acs/admin(config)#
Related Commands
interface
To configure an interface type and enter the interface configuration mode, use the interface command
in Configuration mode. This command does not have a no form.
interface GigabitEthernet [0 | 1]
Syntax Description
Note After you enter the Gigabit Ethernet port number in the interface command, you enter the
config-GigabitEthernet configuration submode (see the following Syntax Description).
Defaults No default behavior or values.
Command Description
show icmp-status Display ICMP echo response configuration information.
GigabitEthernet Configures the Gigabit Ethernet interface.
0 | 1 Number of the Gigabit Ethernet port to configure.
do EXEC command. Allows you to perform any EXEC commands in this mode
(see
do, page A-118).
end Exits the config-GigabitEthernet submode and returns you to the EXEC
mode.
exit Exits the config-GigabitEthernet configuration submode.
ip Sets the IP address and netmask for the Ethernet interface (see ip address,
page A-124).
no Negates the command in this mode. Two keywords available:
• ip—Sets the IP address and netmask for the interface.
• shutdown—Shuts down the interface.
shutdown Shuts down the interface (see shutdown, page A-137).