A-132
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
Configuration Commands
Examples Example 1
acs/admin(config)# logging 209.165.200.225
acs/admin(config)#
Example 2
acs/admin(config)# logging loglevel 0
acs/admin(config)#
Related Commands
ntp server
To allow for software clock synchronization by the Network Time Protocol (NTP) server for the system,
use the ntp server command in Configuration mode. Allows up to two servers. To disable this capability,
use the no form of this command.
ntp server {ip-address | hostname} [ip-address | hostname]
Syntax Description
Defaults No servers are configured by default.
Command Modes Configuration
Usage Guidelines Use this command if you want to allow the system to synchronize with a specified server.
To terminate NTP service on a device, you must enter the no ntp command without keywords or
arguments. For example, if you previously issued the ntp server command and you now want to remove
not only the server synchronization capability, but all NTP functions from the device, use the no ntp
command without any keywords. This ensures that all NTP functions disable and that the NTP service
also terminates.
Note This command will give conflicting information during the sync process. The sync process can take up
to 20 minutes to complete.
Examples acs/admin(config)# ntp server 209.165.201.31
NTP Server was modified. You must restart ACS.
Do you want to restart ACS now? (yes/no) yes
Stopping ACS ......................
Starting ACS ......................
Command Description
show logging Displays list of logs for the system.
ip-address | hostname IP address or hostname of the server providing the clock synchronization.
Arguments are limited to 255 alphanumeric characters.
To Next Page
Loading...
