Cisco CSACS-1121-K9 - Show Logging

A-77
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
Show Commands
Defaults No default behavior or values.
Command Modes EXEC
Usage Guidelines This command displays the state of syslog error and event logging, including host addresses, and for
which, logging destinations (console, monitor, buffer, or host) logging is enabled.
Examples Example 1
acs/admin# show logging system
ADEOS Platform log:
-----------------
Oct 7 13:24:41 localhost debugd[2050]: [2915]: config:network: main.c[238]: Set
up is complete
Oct 7 13:24:51 localhost debugd[2050]: hangup signal caught, configuration read
Oct 7 13:24:51 localhost debugd[2050]: successfully loaded debug config
Oct 7 13:24:51 localhost debugd[2050]: [3482]: icmp: icmputils_cli.c[139]: Generating
icmp echo response config
Oct 7 13:24:51 localhost debugd[2050]: [3482]: icmp: cars_icmpcfg.c[118]: Got the current
ICMP Echo response config as : enabled
Oct 7 13:24:51 localhost debugd[2050]: [3482]: icmp: icmputils_cli.c[160]: Got ICMP echo
config: on
Oct 7 13:24:51 localhost debugd[2050]: [3482]: icmp: icmputils_cli.c[167]: Finished icmp
echo response config generation
Oct 7 13:24:51 localhost debugd[2050]: [3482]: logging: logutils_cli.c[233]: Generating
logging config
Oct 7 13:24:51 localhost debugd[2050]: [3482]: logging: logutils_cli.c[253]: Got
Logserver: localhost
Oct 7 13:24:51 localhost debugd[2050]: [3482]: logging: logutils_cli.c[261]: Got
loglevel: 6
--More-- (press Spacebar to continue)
Example 2
acs/admin# show logging internal
log server: localhost
system Displays the system syslogs.
| Output modifier variables:
• begin—Matched pattern. Up to 80 alphanumeric characters.
• count—Count the number of lines in the interface. Add number after the
word count.
• end—End with line that matches. Up to 80 alphanumeric characters.
• exclude—Exclude lines that match. Up to 80 alphanumeric characters.
• include—Include lines that match. Up to 80 alphanumeric characters.
• last—Display last few lines of output. Add number after the word last.
Up to 80 lines to display. Default 10.