A-133
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
Configuration Commands
To verify that ACS processes are running, use the
'show application status acs' command.
acs/admin(config)#
Related Commands
password-policy
To enable or configure the passwords on the system, use the password-policy command in
Configuration mode. To disable this function, use the no form of this command.
password-policy option
Note The password-policy command requires a policy option (see Syntax Description).
You must enter the password-expiration-enabled command before the other password-expiration
commands.
Syntax Description
Note After you enter the password-policy command, you enter the config-password-policy
configuration submode.
Command Description
show ntp Displays the status information about the NTP associations.
digit-required Requires a digit in the password.
disable-repeat-characters Disables the password’s ability to contain more than four identical
characters.
disable-cisco-password Disables the ability to use the word Cisco or any combination as the
password.
lower-case-required Requires a lowercase letter in the password.
min-password-length Specifies a minimum number of characters for a valid password.
Integer length from 0 to 4,294,967,295.
no-previous-password Prevents users from reusing a part of their previous password.
no-username Prohibits users from reusing their username as a part of a password.
password-expiration-days Number of days until a password expires. Integer length from 0 to 80.
password-expiration-enabled Enables password expiration.
Note You must enter the password-expiration-enabled command
before the other password-expiration commands.
password-expiration-warning Number of days before expiration that warnings of impending
expiration begin. Integer length from 0 to 4,294,967,295.
password-lock-enabled Locks a password after several failures.
To Next Page
Loading...
