Cisco CSACS-1121-K9 - Snmp-Server Location; Snmp-Server Community

A-139
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
Configuration Commands
Syntax Description
Defaults Disabled.
Command Modes Configuration
Usage Guidelines The command takes arguments as listed; otherwise, an error occurs.
Examples acs/admin(config)# snmp-server community new ro 10
acs/admin(config)# snmp-server host 209.165.202.129 version 1 password
acs/admin(config)#
Related Commands
snmp-server location
To configure the SNMP location MIB value on the system, use the snmp-server location command in
Configuration mode. To remove the system location information, use the no form of this command.
snmp-server location word
Syntax Description
Defaults No default behavior or values.
Command Modes Configuration
ip-address IP address of the SNMP notification host. Up to 32 alphanumeric characters.
hostname Name of the SNMP notification host. Up to 32 alphanumeric characters.
version {1 | 2c} (Optional) Version of the SNMP used to send the traps. Default = 1.
If you use the version keyword, specify one of the following keywords:
• 1—SNMPv1.
• 2c—SNMPv2C.
community Password-like community string that is sent with the notification operation.
Command Description
snmp-server community Sets up the community access string to permit access to SNMP.
snmp-server location Configures the SNMP location MIB value on the system.
snmp-server contact Configures the SNMP contact MIB value on the system.
word String that describes the system’s physical location information. Up to 255
alphanumeric characters.