Cisco CSACS-1121-K9 - Show Ports

A-80
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
Show Commands
show ports
To display information about all the processes listening on active ports, use the show ports command in
the EXEC mode.
show ports [|] [|]
Syntax Description
Defaults No default behavior or values.
Command Modes EXEC
Usage Guidelines When you run the show ports command, the port must have an associated active session.
| Output modifier variables:
• begin—Matched pattern. Up to 80 alphanumeric characters.
• count—Count the number of lines in the interface. Add number after the
word count.
|—Output modifier variables (see Table A-12).
• end—End with line that matches. Up to 80 alphanumeric characters.
• exclude—Exclude lines that match. Up to 80 alphanumeric characters.
• include—Include lines that match. Up to 80 alphanumeric characters.
• last—Display last few lines of output. Add number after the word last.
Up to 80 lines to display. Default 10.
|—Output modifier variables (see Table A-12).
Ta b l e A-12 Output Modifier Variables for Count or Last
| Output modifier variables:
• begin—Matched pattern. Up to 80 alphanumeric characters.
• count—Count the number of lines in the output. Add number after the
word count.
|—Output modifier variables.
• end—End with line that matches. Up to 80 alphanumeric characters.
• exclude—Exclude lines that match. Up to 80 alphanumeric characters.
• include—Include lines that match. Up to 80 alphanumeric characters.
• last—Display last few lines of output. Add number after the word last.
Up to 80 lines to display. Default 10.
|—Output modifier variables.