Cisco CSACS-1121-K9 - Show Disks; Show Icmp-Status

A-72
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
Show Commands
Defaults No default behavior or values.
Command Modes EXEC
Usage Guidelines Only platforms that have a disk file system support the show disks command.
Examples acs/admin# show disks
disk: 1% used (48564 of 7063480)
temp. space 2% used (35844 of 2031952)
Internal filesystems:
all internal filesystems have sufficient free space
acs/admin#
Related Commands
show icmp-status
To display file-system information about the disks, use the show icmp_status command in EXEC mode.
show icmp_status {> file | |}
Ta b l e A-10 Output Modifier Variables for Count or Last
| Output modifier variables:
• begin—Matched pattern. Up to 80 alphanumeric characters.
• count—Count the number of lines in the output. Add number after
the word count.
|—Output modifier variables.
• end—End with line that matches. Up to 80 alphanumeric
characters.
• exclude—Exclude lines that match. Up to 80 alphanumeric
characters.
• include—Include lines that match. Up to 80 alphanumeric
characters.
• last—Display last few lines of output. Add number after the word
last. Up to 80 lines to display. Default 10.
|—Output modifier variables.
Command Description
show cpu Displays CPU information.
show memory Displays the amount of system memory that each system process uses.