Cisco CSACS-1121-K9 - Page 111

A-73
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
Show Commands
Syntax Description
Defaults No default behavior or values.
Command Modes EXEC
Usage Guidelines None.
Examples Example 1
acs/admin# show icmp_status
icmp echo response is turned on
acs/admin#
> Output direction.
file Name of file to redirect standard output (stdout).
| Output modifier commands:
• begin—Matched pattern. Up to 80 alphanumeric characters.
• count—Count the number of lines in the output. Add number after the
word count.
– |—Output modifier commands (see Table A-11).
• end—End with line that matches. Up to 80 alphanumeric characters.
• exclude—Exclude lines that match. Up to 80 alphanumeric characters.
• include—Include lines that match. Up to 80 alphanumeric characters.
• last—Display last few lines of output. Add number after the word last.
Up to 80 lines to display. Default 10.
– |—Output modifier commands (see Table A-11).
Ta b l e A-11 Output Modifier Variables for Count or Last
| Output modifier variables:
• begin—Matched pattern. Up to 80 alphanumeric characters.
• count—Count the number of lines in the output. Add number after the
word count.
|—Output modifier variables.
• end—End with line that matches. Up to 80 alphanumeric characters.
• exclude—Exclude lines that match. Up to 80 alphanumeric characters.
• include—Include lines that match. Up to 80 alphanumeric characters.
• last—Display last few lines of output. Add number after the word last.
Up to 80 lines to display. Default 10.
|—Output modifier variables.