Cisco CSACS-1121-K9 - Backup; Application Upgrade

A-28
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
EXEC Commands
Caution Do not issue the backup or restore commands when the upgrade is in progress. This might cause the
database to be corrupted.
Examples acs/admin# application upgrade acs myremoterepository
acs/admin#
Related Commands
backup
To perform a backup (including the ADE OS data) and place the backup in a repository, use the backup
command in the EXEC mode.
backup backup-name repository repository-name
Syntax Description
Defaults No default behavior or values.
Command Modes EXEC
Usage Guidelines Performs a backup of ACS and ADE OS data and places the backup in a repository.
When you are using this command for ACS, the backup files include:
• Database—Database files include data related to ACS as well as the ADE OS. You can view backup
files of the ADE-OS at:
– /storedconfig
– /storeddata
• Database password file—dbcred.cal, located at /opt/CSCOacs/conf.
Command Description
application install Installs an application bundle.
application remove Removes or uninstalls an application.
application start Starts or enables an application.
application stop Stops or disables an application.
show application Shows application information for the installed application packages
on the system.
backup-name Name of backup file. Up to 100 alphanumeric characters.
repository Repository command.
repository-name Location where the files should be backed up to. Up to 30 alphanumeric
characters.