A-42
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
EXEC Commands
Usage Guidelines Use the forceout command in EXEC mode to force a user from an active session.
Examples acs/admin# forceout user1
halt
To shut down and power off the system, use the halt command in EXEC mode.
halt
Syntax Description No arguments or keywords.
Defaults No default behavior or values.
Command Modes EXEC
Usage Guidelines Before you issue the halt command, ensure that ACS is not performing any backup, restore, installation,
upgrade, or remove operation. If you issue the halt command while ACS is performing any of these
operations, you will get one of the following warning messages:
WARNING: A backup or restore is currently in progress! Continue with halt?
WARNING: An install/upgrade/remove is currently in progress! Continue with halt?
If you get any of these warnings, enter YES to halt the operation, or enter NO to cancel the halt.
If no processes are running when you use the halt command or you enter YES in response to the warning
message displayed, ACS asks you to respond to the following option:
Do you want to save the current configuration ?
Enter YES to save the existing ACS configuration. ACS displays the following message:
Saved the running configuration to startup successfully
Examples acs/admin# halt
acs/admin#
Related Commands Command Description
reload Reboots the system.
To Next Page
Loading...
