A-93
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
ACS Configuration Commands
Examples acs/admin# show version
Cisco Application Deployment Engine OS Release: 1.1
Build Version: 1.1.0.416
Copyright (c) 2005-2008 by Cisco Systems, Inc.
All rights reserved.
Hostname: acs
Version information of installed applications
---------------------------------------------
Cisco ACS VERSION INFORMATION
-----------------------------
Version : 5.1
Release : 100
acs/admin#
ACS Configuration Commands
Each ACS Configuration command includes a brief description of its use, command syntax, usage
guidelines, and sample output.
To access the ACS Configuration mode, you must use the acs-config command in the EXEC mode.
This section describes the following Configuration commands.
• access-setting accept-all
• debug-adclient
• debug-log
• decrypt-support-bundle
• export-data
• import-data
• import-export-abort
• import-export-status
• no debug-adclient
• no debug-log
• replication force-sync
• reset-management-interface-certificate
• show debug-adclient
• show debug-adclient
access-setting accept-all
To reset the IP address filtering to allow any IP address to access the management pages of an ACS
server, use the access-setting
accept-all command in the ACS Configuration mode. Only the super
admin has the privilege to use this command on a primary ACS node.
access-setting accept-all
To Next Page
Loading...
