2-2
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Chapter 2 Using the ACS Command Line Interface
Before Accessing the ACS CLI
Starting the CSACS-1121
Complete these steps before you configure the CSACS-1121 appliance:
Step 1 Connect the power cord to the CSACS-1121 (see Figure 2-1).
Figure 2-1 Rear View of CSACS-1121
.
Step 2 Connect the network cable to the Gigabit Ethernet 0 connector (see Figure 2-1). The setup utility (that
appears when the CSACS-1121 boots) only configures the Gigabit Ethernet 0 port. For information on
connecting cables, see the Installation and Upgrade Guide for the Cisco Secure Access Control
System
5.1.
Step 3 Power up the CSACS-1121. The appliance boots automatically and the setup utility appears (see
Running Setup to Configure ACS, page 2-2).
Running Setup to Configure ACS
When you power up the CSACS-1121 appliance for the first time, you are prompted to run the setup
utility to configure the appliance. Before you run the utility using the setup command, ensure that you
have values for the following network configuration prompts:
• Hostname
• IP address
• Netmask
• Gateway
• Domain
• Nameserver
• User ID
• Password
1 AC power receptacle 4 Gigabit Ethernet 0
2 Serial connector 5 USB 3 connector
3 Video connector 6 USB 4 connector
To Next Page
Loading...
