A-48
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
EXEC Commands
Examples acs/admin# restore backup1.tar.gpg repository repository1
acs/admin#
Related Commands
rmdir
To remove an existing directory, use the rmdir command in the EXEC mode.
rmdir word
Syntax Description
Defaults No default behavior or values.
Command Modes EXEC
Usage Guidelines None.
Examples acs/admin# mkdir disk:/test/
acs/admin# dir
Directory of disk:/
16384 Jun 28 2007 00:09:50 lost+found/
Command Description
acs backup Performs a backup of an ACS configuration.
acs-config Enters the ACS Configuration mode.
acs patch Installs and removes ACS patches.
acs reset-config Resets the ACS configuration to factory defaults.
acs reset-password Resets the ‘acsadmin’ administrator password to the default setting.
acs restore Performs a restoration of an ACS configuration.
acs support Gathers information for ACS troubleshooting.
backup Performs a backup (ACS and ADE OS) and places the backup in a
repository.
backup-logs Backs up system logs.
replication force-sync Synchronizes the secondary ACS database to the primary ACS
database.
repository Enters the repository submode for configuration of backups.
show repository Displays the available backup files located on a specific repository.
show backup history Displays the backup history of the system.
word Directory name. Up to 80 alphanumeric characters.
To Next Page
Loading...
