Cisco CSACS-1121-K9 - Debug

A-36
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
EXEC Commands
debug
To display errors or events for command situations, use the debug command in the EXEC mode.
debug {all | application | backup-restore | cdp | | config | icmp | copy | locks | logging | snmp |
system | transfer | user | utils}
Syntax Description all Enables all debugging.
application Application files.
• all—Enables all application debug output. Set level between 0 and 7 with
0 being severe and 7 being all.
• install—Enables application install debug output. Set level between 0
and 7 with 0 being severe and 7 being all.
• operation—Enables application operation debug output. Set level
between 0 and 7 with 0 being severe and 7 being all.
• uninstall—Enables application uninstall debug output. Set level between
0 and 7 with 0 being severe and 7 being all.
backup-restore Backs up and restores files.
• all—Enables all debug output for backup-restore. Set level between 0
and 7 with 0 being severe and 7 being all.
• backup—Enables backup debug output for backup-restore. Set level
between 0 and 7 with 0 being severe and 7 being all.
• backup-logs—Enables backup-logs debug output for backup-restore. Set
level between 0 and 7 with 0 being severe and 7 being all.
• history—Enables history debug output for backup-restore. Set level
between 0 and 7 with 0 being severe and 7 being all.
• restore—Enables restore debug output for backup-restore. Set level
between 0 and 7 with 0 being severe and 7 being all.
cdp CDP configuration files.
• all—Enables all CDP configuration debug output. Set level between 0
and 7 with 0 being severe and 7 being all.
• config—Enables configuration debug output for CDP. Set level between
0 and 7 with 0 being severe and 7 being all.
• infra—Enables infrastructure debug output for CDP. Set level between 0
and 7 with 0 being severe and 7 being all.