A-126
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
Configuration Commands
ip domain-name word
Syntax Description
Defaults Enabled.
Command Modes Configuration
Usage Guidelines If you enter more or fewer arguments, an error occurs.
Examples acs/admin(config)# ip domain-name cisco.com
acs/admin(config)#
Related Commands
ip name-server
To set the Domain Name Server (DNS) servers for use during a DNS query, use the ip name-server
command in Configuration mode. You can configure one to three DNS servers. To disable this function,
use the no form of this command.
Note Using the no form of this command removes all the name servers from the configuration. Using the no
form of this command and one of the IP names removes only that IP name.
ip name-server ip-address [ip-address*]
Syntax Description
Defaults No default behavior or values.
Command Modes Configuration
word Default domain name used to complete the hostnames. Contains at least 2 to
64 alphanumeric characters.
Command Description
ip name-server Sets the DNS servers for use during a DNS query.
ip-address Address of a name server.
ip-address* (Optional) IP addresses of additional name servers.
Note You can configure a maximum of three name servers.
To Next Page
Loading...
