Cisco CSACS-1121-K9 - Show Debug-Log; Show Debug-Adclient

A-110
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
ACS Configuration Commands
Usage Guidelines None.
Examples acs/admin(config-acs)# show debug-adclient
Active Directory client debug is disabled
Related Commands
show debug-log
To display the local debug logging status for all components or for specific ACS components, use the
show debug-log command in the ACS Configuration mode. Any user, irrespective of role, can issue this
command.
show debug-log [component | all]
Syntax Description
Defaults No default behavior or values.
Command Modes ACS Configuration
Usage Guidelines You can select any of the following (including the suboptions) as a component:
• runtime—If you select this component, all other runtime subcomponents are included; see runtime-
items in the list below:
– runtime-admin
– runtime-authenticators
– runtime-authorization
– runtime-config-manager
– runtime-config-notification-flow
– runtime-customerlog
– runtime-crypto
Command Description
debug-adclient Enables debug logging for an Active Directory client.
debug-log Disables debug logging for an Active Directory client.
debug-log Defines the local debug logging level for the ACS components.
show debug-adclient Shows the debug log level status for subsystems (enabled or disabled).
component Selects local debug logging on the components you want, where component
can be any of the components described in the Usage Guidelines.
all Displays the currently configured local debug logging status for all
components.