Cisco CSACS-1121-K9 - Page 173

A-135
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
Configuration Commands
Defaults No default behavior or values.
Command Modes Configuration
Usage Guidelines None.
Examples acs/admin(config)# repository myrepository
acs/admin(config-Repository)# url sftp://starwars.test.com/repository/system1
acs/admin(config-Repository)# user luke password skywalker
acs/admin(config-Repository)# exit
acs/admin(config)#
url URL of the repository. Up to 80 alphanumeric characters (see Table A-20).
user Configure username and password for access. Up to 30 alphanumeric
characters.
Ta b l e A-20 URL Keywords
Keyword Source of Destination
word Enter repository URL, including server and path info. Up to 80 alphanumeric
characters.
cdrom: Local CD-ROM drive (read only).
disk: Local storage.
Note All local repositories are created on the /localdisk partition. When you
specify disk:// in the repository URL, the system creates directories in a
path that is relative to /localdisk. For example, if you entered
disk://backup, the directory is created at /localdisk/backup.
You can run the show repository repository_name to view all the files in
the local repository.
ftp: Source or destination URL for an FTP network server. Use url ftp://server/path
1
.
1. Server is the server name and path refers to /subdir/subsubdir. Remember that a colon (:) is required after the server for an
NFS network server.
nfs: Source or destination URL for an NFS network server. Use url nfs://server:path
1
.
sftp: Source or destination URL for an SFTP network server. Use url sftp://server/path
1
.
tftp: Source or destination URL for a TFTP network server. Use url tftp://server/path
1
.
Note You cannot use a TFTP repository for performing ACS upgrade.